CAD 201 Mono Microphone/Line input module
MIC: Coarse gain select buttons. Highest number active. Pre-set link for +48v.
REF LEVEL: ± 10dB Line input.
LINE: Select with LED on.
PH: Phase change, Line or Mic.
TRIM: Fine adjust ± 15dBs.
80Hz: 12dB/octive H.P.F.
HF: ± 15dB shelving, 6dB/octive.
MID: ± 15dB control. Sweep 120-1k2Hz Q-0.8.
x10: 1k2-12kHz Q-0.8.
LF: ± 15dB shelving, 6dB/octive.
EQ: Equalizer in/out not H.P.F.
A1: Jumper pre or post Fader.
A2: Post Fader only. Cleanfeed select post Fader.
DUCK: Channel controlled from selected master duck. Disabled when selected as master.
PAN: Positions the signal in an stereo image. Unity gain in centre +3dB at each end.
PGM: Assigns channel direct to programme bus.
AUD: Assigns channel direct to Audition module 204.
SUB: Assigns channel direct to Sub-Group module 204.
ON LED: Indicates channel is on, also status of Fader. Green fully off, Orange active.
ON SW: Enables VCA’s. Can be pre-set to control remote stop/start.
PFL: Assigns the panned stereo image to monitor phones, meters or controlroom loudspeakers.
FADER: 100mm. movement. Switch electronic can be pre-set to control stop/start.
Bargraph shows peak PFL level, +18dB 6dB below clip.
Insert points, REF @0dBm. Provides earth compensated send and fully balanced return.
PFL by default is disabled when Fader is opened. Jumper override is provided.
